Select the paper for the report

Navigation:  Report generator in events > Designing an example report >

Select the paper for the report

Previous pageReturn to chapter overviewNext page

Continuing with the example report:


Use the [Paper selection] tab to change the description of the paper in use, and where on the paper you want the report.


The page size should match the paper in your printer.

The unit of measure is your choice, and may be inches or millimeters.

Use the number of columns where you want the report to have two or three rows down the page.


In this example change the top, left and right margins to 1 inch, or 25mm.

Preview the results using [F3].

Go to the page header tab and change the header band height to 50. View again.


Continue to experiment as needed.